3D file ETT MK1 “TwincabTrekker” 🌆 ・3D printable mannequin to obtain・Cults

The ETT MK1 “TwinCab Trekker” is a leaf-spring suspension-based rock-crawling RC automobile.

Its design contains a double-cab passenger compartment with a cargo mattress, twin air intakes, twin exhaust pipes, double twin air horns, and an open roof for a particular look.

A totally purposeful entrance winch has been added, offering each ornamental enchantment and off-road functionality.

The design was impressed by pictures of custom-built actual off-road autos that mix components from numerous autos to create rugged terrain machines.

The entrance and rear leaf-spring suspension mounts embody a number of gap positions, providing numerous choices for adjusting wheelbase and trip peak.

This mannequin is constructed to a 1/10 scale, and the adjustable wheelbase ranges from 355mm to 385mm, relying on the trip peak.

The rear fender place will also be adjusted to match adjustments within the wheelbase.

Two battery tray choices are offered, with the smaller tray providing a a lot decrease middle of gravity.

The seat base peak is obtainable in two choices, with a 5mm distinction, permitting changes to suit totally different driver figures.

Specifically developed components for mounting leaf springs are included, and builders preferring a extra lifelike look may also set up Yota axles with out problem.

Elvis RC follows a design philosophy targeted on straightforward printing, excessive sturdiness, and distinctive aesthetics, and this mannequin completely embodies that philosophy.

https://www.youtube.com/watch?v=llxz5X-TDnc – meeting handbook video

automobile Specs
541 x 221 x 187 (peak) – Solely the 3D-printed physique and chassis
Wheelbase 355mm ~ 385mm

0.4mm nozzle
0.15mm layer peak
mattress temp: 50℃
nozzle temp: 230-240℃
high and backside: 5 layer
wall: 2.0mm
fill: 40%